Fabtech helped me fill some holes in my boat

[cyclone]

so last night we were finishing up the body work on the bottom of my hull and all that was left was the holes in the transom for the old exhaust. I had some 1-inch thick MDF to fill the holes with and nothing to cut it with. Couldnt find the hole saws or jigsaw. So i got resourceful and hammered a couple of 4-inch roundx1-inch thick body lift bushings out of a Fabtech lift kit, into the holes. They fit real snug and then i glassed right over them. The were made of hard plastic so i was able to sand them flush with the transom. Call me crazy but it looked funny and worked really well.

[nitro557]

just check the ups tracking that diverter will be in your door today

[cyclone]

ya i did. thanks. I'm assuming that you got my check then?

[nitro557]

yes im good to go is all fine with you ?

[AntRant]

cyclone, Got any pics of the Rogers project?

[cyclone]

Nitro. Ya the parts look perfect. thanks again.
Antrant- I'll have pictures next week. Got to get them scanned. I just sent the tunnel ram and some other stuff to the chrome shop and should have pictures of the motor all assembled next week too.