PDA

View Full Version : Finished some more stuff on the Schiada


Highlimit9000
01-22-2005, 05:41 PM
Installed My Gauges :sqeyes:
http://www.***boat.com/image_center/data/524/199Gauges3.JPG
Highlimit9000
01-22-2005, 05:43 PM
Mounted the Tanks
http://www.***boat.com/image_center/data/524/199Tank5.JPG
Highlimit9000
01-22-2005, 05:46 PM
Gas Caps and Tank Breathers
http://www.***boat.com/image_center/data/524/199Gasbreathers1.JPG
Highlimit9000
01-22-2005, 05:48 PM
Another Pic from Inside
http://www.***boat.com/image_center/data/524/199Gauges6.JPG
Morg
01-22-2005, 05:50 PM
C,
Guages look nice. I think you need more. Fuel pressure, GPS speedo, Hour meter.....
J/K (except fuel pres.) verry clean install.
Highlimit9000
01-22-2005, 05:57 PM
Im a little worried about where this bulkhead is! I talked with Superdave today to find out where his V-Drived ended up with his 8 Deg Drop thru. He said it was at 105" from transom. I am gonna run same 8 Deg as Dave, and Guess what Sports Fans...105" on my boat from transom puts it right where this Bulkhead is! Just Behind the T-Handle. The other side of the boat is Ok. No Bulkhead...This one is there because I went open stringer for down Pedel Assembly...Should I be worried?
http://www.***boat.com/image_center/data/524/199T-Handle.JPG
GofastRacer
01-22-2005, 07:28 PM
The V-Drive goes at the end of the prop shaft, before you panic put the strut in and run the shaft up and see where it actually goes and go from there!..
VD CRUISER
01-22-2005, 08:18 PM
How far is the end of the strut barrel going to be from the transom. Mine is 23.5" and with my strut being 7.5 deg it puts the V drive mount plate at 109" from the transom. I wouldn't be afraid to have the strut barrel 24 + from the transom on a bigger boat like yours.
That thing sure does look nice inside.
Highlimit9000
01-22-2005, 08:34 PM
After looking at some Pics of Dave's Set-up. I think I will be okay using the same L-Bracket Sandwiched as Prime did for him. So even if the V-Drive comes even with the Bulkhead, The Bolts can be put on each side of the Bulkhead through the stringer..Will see when prime Gets it...Thanks Morg and VD for the Compliments...Been working on it last 2 days! Having Fun though seeing stuff come together...