View Full Version : Prop needed
ao/al2
01-31-2005, 11:01 AM
Hello everyone, does anyone have a rh 17" X 33 pitch 4 blade prop for a #6 drive for sale. thanks guys
Alan
VelocityDriver
01-31-2005, 07:01 PM
Try Throttle Up Props, they should have it in stock. www.throttle-up.com
ao/al2
02-02-2005, 09:24 AM
thanks VD. I will give them a try.
ALan
Ron Hill
02-02-2005, 02:14 PM
I have a 17 1/2 X 34 four blade that has about 5 minutes on it...I could cut it to 17.....maybe depitch to 33....$1,500
www.boatracingfacts.com is where I'll post the pictures...that's not true, I posted them here!
mbrown2
02-02-2005, 10:46 PM
Ron, do you have any used matched cleavers? 14 1/2 28's, 30's, 32's? 3 or 4 blade......big shaft for 300x outboard.
230EAGLE
02-03-2005, 10:47 AM
I Have A Pair Of 32 X 14.5 Brovo 1 4 Blade Props. They Have Been Labbed Finished And Are In Perfect Condition. Give Me A Call At 559-268-4323.
Erik
mbrown2
02-03-2005, 11:28 AM
I Have A Pair Of 32 X 14.5 Brovo 1 4 Blade Props. They Have Been Labbed Finished And Are In Perfect Condition. Give Me A Call At 559-268-4323.
Erik
Thanks, but I am looking for Cleavers..
ao/al2
02-14-2005, 07:55 AM
02-02-2005 10:14 PM
Ron Hill I have a 17 1/2 X 34 four blade that has about 5 minutes on it...I could cut it to 17.....maybe depitch to 33....$1,500
www.boatracingfacts.com is where I'll post the pictures...that's not true, I posted them here!
02-02-2005 05:24 PM
Hey ron, damn I wish i would have saw this reply earlier, I wish you guys would have told me this when I called you guys. I was the guy that called about needing a prop for an Arneson drive. 1,500 sounds good but I found the prop in florida but it cost me more. Anyways thanks for looking out. Oh wait, you are from Hill Props? if not then sorry wrong guy. lol
AL
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.