Question about putting a motor in a jet boat..

[al cole'holic]

..I might have put this in the wrong section earlier so here I am..I am thinking about pulling a complete Merc motor out of a boat that has a Bravo drive and dropping it into a boat with a jet drive. Is this an easy engine swap or what?? :)

[Hustler]

It should'nt be a big deal, You'll need a take off flange and a new H bar, do you have jet motor plates or were going to try and use the merc stuff?

[al cole'holic]

It should'nt be a big deal, You'll need a take off flange and a new H bar, do you have jet motor plates or were going to try and use the merc stuff?
...wassup Hustla :D
I guess I was gonna try to use whatever I have, just looking to minimize what I would have to buy to make the swap...

[BrendellaJet]

as long as there is room for it and its carburated, I dont think it would be that tough...

[old rigger]

al cole'holic,
mind if I ask what you're going to do with the bravo drive and all the hardware you're gonna have left over?