PDA

View Full Version : Schiada FLAT 17' 10" FOR SALE



sifocalpoint
12-28-2005, 04:11 PM
http://www.dmontzsta.com/MiscStuff/MiscPics/RyansPics/
The boat is a 17'10" Schiada Flatbottom V-Drive
Heavy Duty Tandom Axle Trailer with new steel fenders which need bolted on, and the trailer is ready to be cleaned up and sprayed, new bunks, and tires are pretty good for a long haul. THIS IS NOT THE TRAILER IN THE PIC, it was on a single and i got a tandom this past year.
PARTS All BRAND NEW NO JUNK
Grab Handle
Vented BAcking Plate
Left Foot Fabricated Purple Foot Pedal With Hardware (Cav Plate)
2 Purple Water Dumps
2 Purple Fuel Vents
Dual Spring Setup (Cav Plate)
Extra Single Spring Kit
Steering Shaft Tube
Formuling 9 Bolt Polished Alum Wheel/ White Leather
Purple 9 Bolt Hub Center
Fabricated Foot Throttle Purple With Stringer Mount
Purple Exhaust Block Offs
Polished Front Bow Eye
Polished Thru Hull Fitting
Polished Billet Cav Plate Handle
Purple Billet Battery Box
Purple Deck Guage Pod
Billet Purple Cut Transom Blocks
Billet Polished Plate Feet
Polished Turnbuckles
Purple Billet Control Arm
Purple Cavitation Plates (Ready to bolt on, Prime Marine matched up the old ones)
Polished Strip Below Plate Feet To Offset The Purple
Custom Transom Plate (Behind Transom Blocks)Purple Milled Slots From Prime Marine
Autometer Marine White Guages
3 3/8 8000 rpm tach
2 5/8 Volt 2 5/8 Water temp 2 5/8 Oil Pressure
All Purple Guage Bezels
Gaffrig Boost Guage For Guage Pod
2 Chrome T Handle Drain Plugs
Push Pull Switch with billet purple pump knob and bezel
Key Switch and Purple Bezel
2 Fiberglass Canyon Marine Buckets White and Purple NEVER USED!!
All Hallcraft Steering In Perfect Shape
Alum Seat Braces from Canyon Marine
Motor Plates BBC with Billet Feet (34" forward from transom)
Alum Rails / Backing Plates
All Steel Running Gear still in boat
New alum Rudder brace with self aligning flange bearing and locks
Steering and rudder quadrant etc not pictured but i have it and all in great shape.
Other MISC. Things
Boat needs painted, trailer isnt a rusty mess but needs painted, the boat needs a gearbox and minor odds and ends. Could easily be in water by summer.
$4000.00
PM me for more info or my phone #

Squirtin Thunder
12-28-2005, 04:17 PM
http://www.dmontzsta.com/MiscStuff/MiscPics/RyansPics/10.JPG

sifocalpoint
12-29-2005, 04:49 PM
Huffpower check your PM's

sifocalpoint
12-30-2005, 11:38 PM
Would consider a trade for a jet drive race pump (a new one) with a stainless impeller, inducer, snoot, diverter, 17-4 shaft etc.
I do not want a used pump, but a new one, complete ready to place in a new hull maybe in the near future.