pulling droop for zerk?

[Riverat84]

i found the zerk fitting on my aggressor bowl, but cant access it cuz of the middle wall in my droop that (i guess) prevents the tumble/roll of water....does that mean i have to pull the droop/nozzle ass. ?
cuz i have an assload of droop gaskets if i need to.
Reid

[Squirtin Thunder]

Yes it is much easier !!! :cool:

[Riverat84]

alright, thanx jim...all i gotta worry about is the steering linkage right? i dont have to take off the lines/hydraulics? just have something to set the assembly on next to the bowl right? thanx.
Reid

[Squirtin Thunder]

Yes !!! :cool:

[poncho-pwr]

Duct tape the end of your grease gun hose to a long screwdriver and give it a shot first, it should work. I do this to mine all the time.

[Riverat84]

yeah, but even w/ that, it didnt work...the 'wall' went all the way up to the nipple, so i had to take it off...nipple was rusted SHUT so i went and bought a new one and put it on....i took the big red nut off just to check how much would be in there, and water came out! like almost a cupfull! there was some grease way back in it, so i just pumped it until it was full....worked well! gasket fit great and its back on...thanx jim and poncho.
Reid

[502 JET]

You can get stainless zerk fittings from Totally Stainless.http://totallystainless.net/totally.html

[Riverat84]

You can get stainless zerk fittings from Totally Stainless.http://totallystainless.net/totally.html
hey thanx bud, ill check it out...the thing was totally rusted!
Reid

[sanger rat]

If you use plastic wedges you don't need to mess with gaskets.

[Squirtin Thunder]

If you use plastic wedges you don't need to mess with gaskets.
Package on the way !!! :yuk: