View Full Version : Where do you check the tolerance for the impeller
CVX20Dustin
06-25-2005, 11:22 AM
I'm rebuilding my JE pump and was wondering where do you check the tolerances and what should they be for the impeller. The kit came with shims.
I have two rubber hose pieces left that I don't know where they go.
Ones 3/4"by 1" long and the other one is 3/8" by 1/2 long.
Wicked Performance Boats
06-25-2005, 04:38 PM
You check clearance between the lip of the impeller and the wear ring. no tighter than .025. The 2 pieces of hose seal the steering tube at transom. Budlight
Oldsquirt
06-25-2005, 10:45 PM
I have two rubber hose pieces left that I don't know where they go.
Ones 3/4"by 1" long and the other one is 3/8" by 1/2 long.
With a JE pump you wont need either of those hoses. For a JC or JG they would be the steering tube seal and the reverse cable seal, respectively.
CVX20Dustin
06-25-2005, 10:59 PM
Thanks for the info guys.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.