msmeads1
07-31-2005, 10:39 AM
Hi Wayne and Jerry
I found a guy in Kanas that will build me a set of stacked 10" X 33",.090 wall alum tanks. Everyone esle was .065 wall, to thin. Plus there price was off the cart. This guy builds buggy tanks as a manufactor. Dans Performance Parts is the West Coast Dist.
Check them out at
www.dansperformanceparts.com/buggy/fuel/buggyfuel1.htm
Need to know the spacing of the side brackets? I am guesing if the width of the stringers are 24", than they look like they extend 2" on each side, for a total span of 30"? )Wayne, I have your bracket as a template for the side brackets) just need to know the spacing? Can you please measure yours?
One last question? The fuel bungs. Looks like three on top for return (drivers side), one on botton for fuel (middle)? -10 or 1/2, is that correct?
Please let me know? :2purples:
PM or please post reply.
Thanks guys.
Jon.
I found a guy in Kanas that will build me a set of stacked 10" X 33",.090 wall alum tanks. Everyone esle was .065 wall, to thin. Plus there price was off the cart. This guy builds buggy tanks as a manufactor. Dans Performance Parts is the West Coast Dist.
Check them out at
www.dansperformanceparts.com/buggy/fuel/buggyfuel1.htm
Need to know the spacing of the side brackets? I am guesing if the width of the stringers are 24", than they look like they extend 2" on each side, for a total span of 30"? )Wayne, I have your bracket as a template for the side brackets) just need to know the spacing? Can you please measure yours?
One last question? The fuel bungs. Looks like three on top for return (drivers side), one on botton for fuel (middle)? -10 or 1/2, is that correct?
Please let me know? :2purples:
PM or please post reply.
Thanks guys.
Jon.