PDA

View Full Version : Water Pump


Kindsvater Flat
08-29-2005, 06:38 PM
Can you get the seal for these pumps at a bearing/seal store or do you have to buy a factory one?
http://www.schoutenranch.com/miscboat/440/3pump.JPG
INEEDAV
08-29-2005, 06:56 PM
Figure out what the sound was the motor made when you had it out yet?
Kindsvater Flat
08-29-2005, 06:58 PM
Haven't touched it.
INEEDAV
08-29-2005, 07:00 PM
Haven't touched it.
Busy farming?
Kindsvater Flat
08-29-2005, 07:13 PM
Harvesting watermelons. So I have been busy repairing stuff most of the weekend and sat on the dozer closing ditches for about 6 hrs this morning. Not to mention I have been having some hip issues. Once we get caught up around here I will yank it out.
Rexone
08-29-2005, 07:47 PM
Not to mention I have been having some hip issues. Once we get caught up around here I will yank it out.
Perhaps have a doctor take a look first. Just a thought.
On the seals I don't think they are available from normal bearing houses. I have one on the shelf if you need (along with bearings if you need).
Kindsvater Flat
08-29-2005, 07:59 PM
I knew you would. Might have to call and get one of those BGMAN discounts.:D
Blown 472
08-30-2005, 04:17 AM
I knew you would. Might have to call and get one of those BGMAN discounts.:D
Hey, what are you using for pistons in your blown motta???
Kindsvater Flat
08-30-2005, 05:10 AM
Ross flat tops. Moved pin to get the compression 8:1
Blown 472
08-30-2005, 05:14 AM
Ross flat tops. Moved pin to get the compression 8:1
How far are they down in the hole?
Kindsvater Flat
08-30-2005, 04:19 PM
How far are they down in the hole?
.140
Heatseeker
08-30-2005, 04:27 PM
Mike, do you have a bearing number?
I have access to a pretty good stock of bearings.
Let me know.
Rexone
08-31-2005, 01:42 AM
6002NSE C3
Nachi Japan
We have in stock if you need - $10.75 ea