Casting Numbers

[460 jus getn it]

I have a set of heads that i picked up. I think they are 84-87 460 ford . the casting number on the side says E7TE. Does anyone know what type of heads these are........ Thanks 460 :confused: :confused: :confused:

[058]

From the casting no. they are 87 truck heads and if I remember correctly early std. 460 intake manifolds will not work due to port mismatch.

[Pantera24-650hp]

See Mortec website, they have all the casting numbers listed.

[460 jus getn it]

058, are these heads worth getting rebuilt and running in my motor? And what type of intake will best fit these heads....... jawdrop

[Blown 472]

You should find some dove's or d3ve's depending on what comp you want to run. Also check out reincarnation-automotive.com some info on heads and stuff. wink

[460 jus getn it]

blown472, these heads are 92cc. im looking to run 9.5-1 comp. these heads are off of a 88 ford. my problem is that an 88 460 was fuel injected. will these heads accept a 460 intake manifold? eek! :confused:

[Blown 472]

I am not sure, I think you might have trouble on the exhaust side also, go check out that site, there is some info on those heads.

[058]

460 jus getn it:
058, are these heads worth getting rebuilt and running in my motor? And what type of intake will best fit these heads....... jawdrop As I understand it the manifold will physically fit but the intake ports will be mis-matched. Try to find some C8 C9 or D0VE-C heads if you want a C/R on the high side or a set of D3VE-A2A heads for a lower C/R, Do not bother with the D2 heads as these are usually open chamber type and are prone to detonation.

[460 jus getn it]

So basically i have two new boat anchors....... jawdrop