jockorace
10-17-2005, 08:39 PM
This is a Sonny Bryant built motor recently (50 hrs ago) rebuilt at Dougan's in Riverside, Ca. It is 355 c.i. w/ Dart heads, S/S severe duty valves, roller rockers,
steel crank, balanced, etc. All the good tricks like lifter valley ground smooth, screens over oil return openings. The compression ratio is approx. 8.5-1. The turbo's make about 12 psi of boost at 6800 rpm. This little motor is very docile at slower speeds, however it still spins a Bravo 1 (1:50-1 ratio) w/ 26 pitch 4-blade 6800 rpm, in a 20' Silverwing tunnel. That is over 100 mph. I'm selling this motor in order to go BIG cube (472) all aluminum small block with bigger turbos or blower. I'm looking to get $5,500 I would consider selling just the Turbo setup (intake,intercoolers,carb,turbos,exhaust,tailpipes ) for $1,500 Contact Dave at 763-295-8004 or jockorace@tds.net
http://www2.***boat.com/image_center/data/500/874BoatStuff_001-med.jpg
steel crank, balanced, etc. All the good tricks like lifter valley ground smooth, screens over oil return openings. The compression ratio is approx. 8.5-1. The turbo's make about 12 psi of boost at 6800 rpm. This little motor is very docile at slower speeds, however it still spins a Bravo 1 (1:50-1 ratio) w/ 26 pitch 4-blade 6800 rpm, in a 20' Silverwing tunnel. That is over 100 mph. I'm selling this motor in order to go BIG cube (472) all aluminum small block with bigger turbos or blower. I'm looking to get $5,500 I would consider selling just the Turbo setup (intake,intercoolers,carb,turbos,exhaust,tailpipes ) for $1,500 Contact Dave at 763-295-8004 or jockorace@tds.net
http://www2.***boat.com/image_center/data/500/874BoatStuff_001-med.jpg