Mesa Racing Engine runner up @Orlando street finals

[MESA BALANCING]

Ok gear heads I know it's not a marine engine but it shows the R and D we do with the parts we use in our racing and poker run engines here are some pics of the 55mm cam bearings we've used for years in the racing engines and the oval port big chief heads we're currently using in our MB800na which is 800 hp naturaly aspirated single 4 bbl carb pump gas engines and the combustion chamber desighn were currantly using which enables us to make that power on pump gas . Hope you guys enjoy . P.S. were spraying three stages of 200hp for a total of 600 hp on spray alone .

[Taylorman]

Wheres the pics?

[MESA BALANCING]

For The Life Of Me I Can't Post Pics On ***boat No Matter What I Do.

[steelcomp]

Can you get them in the image center???
Oval port Big Chiefs. That brings back memories. When I was at Dart, I was given the job of taking a roll of emery cloth and modifying Big Chief sand castings to make the first 5 sets of Big Chief oval ports. They were for some boat guy. Go figure. :cool:

[Squirtin Thunder]

For The Life Of Me I Can't Post Pics On ***boat No Matter What I Do.
Call me in the AM and I will walk you through it.