Poxy putty

[Glencoe MiniDay]

I was curios if anyone knew how much Poxy Putty would I need to set my intake in the hull?
The dimensions of the intake are.
20.75 inches lond By 8 inches wide.

[396_WAYS_TO_SPIT]

check your pm's....
I would but the quart size. I ran out when I used a pint kit. Here is the link.....
http://shopping.rexmar.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=epoxyseagoin

[tahitijet]

I was curios if anyone knew how much Poxy Putty would I need to set my intake in the hull?
The dimensions of the intake are.
20.75 inches lond By 8 inches wide.
I used a quart on my set back. barely and i mean barely had enough, I had to cut the tops off the cans and clean them spotless to get enough. If your not doing a set back the quart is fine. if you are use the quart wisely and you'll be fine.

[HammerDown]

Get extra...I did and thankful of it.
4 cans wasn't enough...for my setback
http://www.***boat.com/image_center/data/500/1064DSC00026-med.jpg

[502 JET]

Get extra...I did and thankful of it.
4 cans wasn't enough...for my setback
http://www.***boat.com/image_center/data/500/1064DSC00026-med.jpg
WOW thats one heck of a pile!How long does this stuff last before it starts to kick?

[tahitijet]

WOW thats one heck of a pile!How long does this stuff last before it starts to kick?you'll have plenty of time.. if i remember right it took a few hours in 100+ temps for it to harden up to the touch and 24 to fully dry. I think working time is 30mins to an hour???? i don't remember i just know it's plenty of time.

[Mighty Thor]

The beautiful thing about this stuff is that it stays put so that you don't have to really worry about it running or sagging while it sets.