Fiat48
11-12-2005, 09:25 PM
I have a BBC on a stand in my front shop. The owner has desided to sell it. All I know about it at this time is:
It's a 4 bolt main low deck block. Either .030 or .060 over.
Steel crank and I THINK 7/16 rods.
High compression..probably around 12.5 to 1.
Open chamber 990 heads. Not sure of any work done.
Roller rockers, roller cam.
It's been balanced.
Tunnel ram and 2 660 Holleys, fuel lines, etc.
Complete motor less oil pan and ignition.
This motor ran 100 mph in my flat (heavy tr-1) in Red Bluff California about 4 years ago. It was supposed to be fresh then and it only ran about 4 runs in my flat after that. Since then it has sat on a stand.
The motor will have to come apart and be inspected, see what it really is and anything corrected that needs it. Which will be taken care of.
The price is $5K. I didn't set the price, he did. Any machine work or repairs needed I will do for free and any parts needed he will buy. So bottom line is $5K. You're welcome to be here through entire process of inspection/rebuilding or whatever it needs.
If this is someone's cup of tea.....pm me.
It's a 4 bolt main low deck block. Either .030 or .060 over.
Steel crank and I THINK 7/16 rods.
High compression..probably around 12.5 to 1.
Open chamber 990 heads. Not sure of any work done.
Roller rockers, roller cam.
It's been balanced.
Tunnel ram and 2 660 Holleys, fuel lines, etc.
Complete motor less oil pan and ignition.
This motor ran 100 mph in my flat (heavy tr-1) in Red Bluff California about 4 years ago. It was supposed to be fresh then and it only ran about 4 runs in my flat after that. Since then it has sat on a stand.
The motor will have to come apart and be inspected, see what it really is and anything corrected that needs it. Which will be taken care of.
The price is $5K. I didn't set the price, he did. Any machine work or repairs needed I will do for free and any parts needed he will buy. So bottom line is $5K. You're welcome to be here through entire process of inspection/rebuilding or whatever it needs.
If this is someone's cup of tea.....pm me.