Tunnel Ram and NOS Question

[Sanger Jet]

I have an old Offy 360 Tunnel with Dual Edelbrock#1407 (750) squirters on it.
Engine is BBF 533 stroker.....all the goodies. What would be the easiest way to put Nos on my setup? Thanks, Darren

[Taylorman]

I have an old Offy 360 Tunnel with Dual Edelbrock#1407 (750) squirters on it.
Engine is BBF 533 stroker.....all the goodies. What would be the easiest way to put Nos on my setup? Thanks, Darren
I would think a dual plate cheater kit would be the easiest.

[robsquezn]

id call jeff prock @ applied nitrous technology he can put a spray bar in it
dont wast your time with plates on a ram thay dont work for shit..
his # is (813)885-4149
or call mike nelson @ nitrous supply co (909)896-3533

[Squirtcha?]

I'm running a tunnelram with 660 center squirters. I'm using the Edelbrock Performer nitrous kit, you can order additional plates and that's what I did (originally a kit for single carb), then split the solenoids with a -3 AN T. It might not be the best way to do it, but it works great for me and it was cheap. I'm running 75 hp on each plate. Due to the smallest solenoids, that's the max hp I can run unless I got bigger on the noids.
In the picture you can see the nitrous solenoid. The line out goes through the hole in the tunnelram and T's on the other side to each plate. You can see the same setup coming from the other side and splitting to the plates on our side of the picture. It plumbed up fairly clean and works slick. Shorter hardline runs would probably be preferred, but this has never been a problem and has always worked fine for me.
http://www.jetheaven.us/photopost/data/500/19fuel_distribution.jpg

[FASTRAT]

I have an old Offy 360 Tunnel with Dual Edelbrock#1407 (750) squirters on it.
Engine is BBF 533 stroker.....all the goodies. What would be the easiest way to put Nos on my setup? Thanks, Darren
the "easiest" would be plates...but if it were mine...i would drill & tap the manif runners & put nozzles in them...IMO much cleaner & work better...especially with that c.i. mtr...just my .02 cents
fastrat

[Taylorman]

I'd like to have the fogger kit that fits below the intake.

[Sanger Jet]

I prob. should have done something while the manifold was off.......Just remounted it last night :220v:
I'll wait till after breakin then make a decision, Thanks again, Darren

[MACHINEHEAD]

Top shots are pretty cheap/easy and work really well. Never tried one on an ede. carb because of the secondary air door . Just make sure its wide open before you press the button

[stompnstang]

go with a dir port inject on a ram. i have never had good luck with plate kit on a ram wet up. i have a work up sheet on setting up a ram str8 from nos if your interested in it
it gives a hole run down on the bigger volume intakes and how to set them up right