TPI
05-26-2006, 02:51 PM
Hot Boat Members,
I have fabricated a new line of scoops for "Big Motors". They are wide enough to fit over the top of a quad rotor motor in most applications. The inside dimensions are 20 5/8"w x 31 1/4L x only 8 1/8"H. There are a bunch of people out there with really nice motors/boats that are looking for a nice wide/low profile scoop to deliver the air and look cool and up to date. I currently have several in stock. I have advertising scheduled for Mid June, but this is just a little info and an opportunity for someone to grab one or two beforehand. They come in all white gel and "top half" carbon fiber w/black gel lower. Due to the configuration, full carbon fiber is not a possibility, without a BUNCH of time involved. Each scoop will require less than one hour of prep from a body/paint guy prior to laying on the candy color! :rollside: I have a lot of East Coast guys that are fired up about the top half carbon fiber, because they can spray the colors of their boats up the sides and have a carbon fiber top. You are only limited by your imagination. I also have a custom air brush/painter that will do just about anything. He's good! These scoops are not cheap, I know, but they cost quite a bit when it's all said and done, and they look very, very nice on the boat!
White gel TPI Scoop $695
Carbon Fiber/Top $995
Thanks guys for looking and for all of the assistance in this project.
http://www.***boat.com/image_center/data/520/383scoops_001m.jpg
http://www.***boat.com/image_center/data/520/383scoops_003m.jpg
http://www.***boat.com/image_center/data/520/383scoops_004m.jpg
http://www.***boat.com/image_center/data/520/383small_scoop.jpg
I have fabricated a new line of scoops for "Big Motors". They are wide enough to fit over the top of a quad rotor motor in most applications. The inside dimensions are 20 5/8"w x 31 1/4L x only 8 1/8"H. There are a bunch of people out there with really nice motors/boats that are looking for a nice wide/low profile scoop to deliver the air and look cool and up to date. I currently have several in stock. I have advertising scheduled for Mid June, but this is just a little info and an opportunity for someone to grab one or two beforehand. They come in all white gel and "top half" carbon fiber w/black gel lower. Due to the configuration, full carbon fiber is not a possibility, without a BUNCH of time involved. Each scoop will require less than one hour of prep from a body/paint guy prior to laying on the candy color! :rollside: I have a lot of East Coast guys that are fired up about the top half carbon fiber, because they can spray the colors of their boats up the sides and have a carbon fiber top. You are only limited by your imagination. I also have a custom air brush/painter that will do just about anything. He's good! These scoops are not cheap, I know, but they cost quite a bit when it's all said and done, and they look very, very nice on the boat!
White gel TPI Scoop $695
Carbon Fiber/Top $995
Thanks guys for looking and for all of the assistance in this project.
http://www.***boat.com/image_center/data/520/383scoops_001m.jpg
http://www.***boat.com/image_center/data/520/383scoops_003m.jpg
http://www.***boat.com/image_center/data/520/383scoops_004m.jpg
http://www.***boat.com/image_center/data/520/383small_scoop.jpg