TJS
05-30-2006, 05:17 AM
I am putting a small shot of Nitrous on this motor. It has all forged internals and the compression is not too high. I am going to go with a 150 shot. I have a mix match of nitrous parts. I am running NOS solenoids and a Nitrous Express Hitman plate set up. I wanted to make sure I do not run out of fuel so I made and auxiliary fuel rail that will feed the fuel solenoid. I am also running a clay smith fuel pump as well. I am not done with all the fittings and lines as of yet, but I will be soon. I was able to mount the nitrous solenoid on the left rear of the intake with a bracket I fabricated. This engine will be getting dynod in a couple of weeks and I am going to test the nitrous as well.
Here are some pics of what I have so far. Note in the pics you will see a auto thermostat and hose set up. I did this so I can dyno it and run it on my engine test stand as well.
T.J.
www.tjsperformance.com
http://www.tjsperformance.com/images/nxfuelrail1.jpg
http://www.tjsperformance.com/images/nxfuelrail2.jpg
http://www.tjsperformance.com/images/nxfuelrail3.jpg
http://www.tjsperformance.com/images/nxfuelrail4.jpg
http://www.tjsperformance.com/images/nxfuelrail5.jpg
http://www.tjsperformance.com/images/nxfuelrail6.jpg
http://www.tjsperformance.com/images/nosbracket1.jpg
http://www.tjsperformance.com/images/nosbracket2.jpg
Here are some pics of what I have so far. Note in the pics you will see a auto thermostat and hose set up. I did this so I can dyno it and run it on my engine test stand as well.
T.J.
www.tjsperformance.com
http://www.tjsperformance.com/images/nxfuelrail1.jpg
http://www.tjsperformance.com/images/nxfuelrail2.jpg
http://www.tjsperformance.com/images/nxfuelrail3.jpg
http://www.tjsperformance.com/images/nxfuelrail4.jpg
http://www.tjsperformance.com/images/nxfuelrail5.jpg
http://www.tjsperformance.com/images/nxfuelrail6.jpg
http://www.tjsperformance.com/images/nosbracket1.jpg
http://www.tjsperformance.com/images/nosbracket2.jpg