Freeze plug ?

[CVX20Dustin]

I had one of my freeze plugs fall out and was wondering if I could use a rubber expansion plug instead of a freeze plug. I can't get a swing to nock the freeze plug in.Will the rubber plug hold up to the presser of the jet.

[ONAROLL]

yes, no problem...........

[jbone]

I hope so, 4 of my plugs are rubber.
I like to get the sand out every now and then.
J

[CVX20Dustin]

Thanks, did know how the hell I was going to get the plugs in there. This is going to be a lot easier.

[TIMINATOR]

I allways keep a couple of the rubber ones in the boat for spares and a wrench to tighten it. Had one fall out of my first jet in 1975, have never needed the spares, but you never know...... TIMINATOR

[Moneypitt]

Double up on the bildge pumps and stay close to shore, when the rubber plug falls out, hammer the gas, just to see how fast you can sink the boat........MP

[jbone]

I forgot to mention that I run a bypass system. This keeps the pressure in the block down to about 20lb or less.
This should reduce the risk of popping a plug out.
J