View Full Version : How do I change Impellars????
DansBlown73Nordic
04-19-2003, 08:58 AM
I have a Neovane in my Schiada. I discovered it is shot. How do I get the old one off? I see a pin it sets on. I thought it just sat on the pin, I tried to pry it off with my favorite tool the Screwdriver.... :D But not having any luck.HELP
126driver
04-19-2003, 09:01 AM
Knock the pin out. Use my favorite tool, the hammer. :D There should be a new one included with the new impeller kit.
[ April 19, 2003, 10:02 AM: Message edited by: 126driver ]
DansBlown73Nordic
04-19-2003, 09:04 AM
It just pushes thru the shaft?
126driver
04-19-2003, 09:09 AM
Yep. Use a punch and tap it out.
Stab-n-Steer
04-20-2003, 08:26 AM
126driver:
Knock the pin out. Use my favorite tool, the hammer. :D There should be a new one included with the new impeller kit. Driver,
I have never got a new hammer with an Impeller kit :confused: Where do you buy your impeller kits? I sure could use a new hammer! wink
Seriously, Aren't those pins tapered, so that you have to drive them out from the small end?
S&S
DUCKY
04-20-2003, 08:46 AM
No, they are knurled so they stay in the rubber, but they are not tapered.
DansBlown73Nordic
04-20-2003, 02:18 PM
I should have read the instructions.... smile_sp
DansBlown73Nordic
04-20-2003, 02:18 PM
[ April 20, 2003, 04:09 PM: Message edited by: Dans66Stevens ]
Thunderbutt
04-20-2003, 06:25 PM
Dans66Stevens:
I should have read the instructions.... smile_sp Hay Dan, thats the first thing I through away
GofastRacer
04-20-2003, 06:36 PM
Dans66Stevens:
I should have read the instructions.... smile_sp What's the saying!, "If all else fails, read the instructions"!.. :D :D :D
Stab-n-Steer
04-21-2003, 05:47 AM
DUCKY:
No, they are knurled so they stay in the rubber, but they are not tapered. Thanks Ducky,
I must have been thinking of something else that is tapered :D
S&S
126driver
04-21-2003, 06:53 AM
Stab-n-Steer:
126driver:
Knock the pin out. Use my favorite tool, the hammer. :D There should be a new one included with the new impeller kit. Driver,
I have never got a new hammer with an Impeller kit :confused: Where do you buy your impeller kits? I sure could use a new hammer! wink
Seriously, Aren't those pins tapered, so that you have to drive them out from the small end?
S&S Minus ten points for grammar. :rolleyes: :D
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.