Schiada76
01-13-2006, 11:55 AM
I finally beat J540 into submission and he's making a batch of water pumps.
They will have a -16 intake and a -16 outflow. He is going to use the same Jabsco impeller as the Magnaflow. He will also make some with two chambers that will have a -16 in and out on each chamber for intercooled deals.
He runs his current set up with one chamber feeding the chiller only and the other splitting the -16 to two -12's, into his CMI headers, into block and out two dumps on his 588 w/1471 injected deal. He says this generates a total of 5-8#'s pressure at the outflow (end of line). The single chamber will empty a 5 gal bucket in 9 secs. at 800 rpm. These can be run on injected or non injected setups.
He doesn't have a firm price yet :rolleyes: but says they should be around three hundred bucks.
I can e-mail some pics if someone wants to post them.
They will have a -16 intake and a -16 outflow. He is going to use the same Jabsco impeller as the Magnaflow. He will also make some with two chambers that will have a -16 in and out on each chamber for intercooled deals.
He runs his current set up with one chamber feeding the chiller only and the other splitting the -16 to two -12's, into his CMI headers, into block and out two dumps on his 588 w/1471 injected deal. He says this generates a total of 5-8#'s pressure at the outflow (end of line). The single chamber will empty a 5 gal bucket in 9 secs. at 800 rpm. These can be run on injected or non injected setups.
He doesn't have a firm price yet :rolleyes: but says they should be around three hundred bucks.
I can e-mail some pics if someone wants to post them.