nos question

[moparjet]

looking to put a n/x dual plate system on the mopar....i would like to see some pics of peoples set ups....and any advise on installing it and set up...going to be using a msd retard box with it....i want to install as cleanly as possible...thanks

[wsuwrhr]

This thread is worthless without pictures.
Post some up of your Mopar boat. Don't be scared.
Clean nitrous install?
Brian
http://www.***boat.com/image_center/data/500/63newnos.jpg

[moparjet]

http://www.***boat.com/image_center/data/520/3359100_0148.JPG http://www.***boat.com/image_center/data/520/3359100_0159.JPG
HERE YOU GO

[wsuwrhr]

Dats nice
http://www.***boat.com/image_center/data/520/3359100_0148-med.JPG http://www.***boat.com/image_center/data/520/3359100_0159-med.JPG
One more
Water outlets:
http://www.***boat.com/image_center/data/520/63waterplates.jpg

[kachina_labala]

Ive been workong on putting Nitro on a dual quad motor. One Issue that I have had with the plate system is there isint enough room in between the carbs for the fuel and nitrous lines. The nitrous works system was designed with sideways mounted carbs not inline like mine (or like yours apear to be). The fuel / nitro lines come in the front and rear of the plate. From what ive seen most plates are like this. Be very careful when selecting the plates to insure you either have carbs you can turn sideways, side feed plates, or enough clearence between the carbs for the lines to clear each other. I had to purchase 90's for the middle lines and they only clear if you turn them so they are back to back (lines feed out oppisite directions). Also dont forget a fuel pressure and full throttle switch for the saftey of your motor. Most kits dont seem to come with them.