PDA

View Full Version : motor going back in cole cruiser


cole555
11-01-2006, 06:17 PM
http://www.***boat.com/image_center/data/524/3775DSC03065-med.JPG
cole555
11-01-2006, 06:19 PM
http://www.***boat.com/image_center/data/524/3775DSC03064-med.JPG
cole555
11-01-2006, 06:20 PM
http://www.***boat.com/image_center/data/500/3775DSC03066-med.JPG
cole555
11-01-2006, 06:28 PM
http://www.***boat.com/image_center/data/524/3775DSC03057-med.JPG
cole555
11-01-2006, 06:29 PM
http://www.***boat.com/image_center/data/520/3775DSC03059-med.JPG
cole555
11-01-2006, 06:30 PM
http://www.***boat.com/image_center/data/524/3775DSC03051-med.JPG http://www.***boat.com/image_center/data/500/3775DSC03058-thumb.JPG http://www.***boat.com/image_center/data/524/3775DSC03052-thumb.JPG
cole555
11-01-2006, 06:32 PM
http://www.***boat.com/image_center/data/524/3775DSC03062.JPG
cole555
11-01-2006, 06:35 PM
http://www.***boat.com/image_center/data/524/3775DSC03055-med.JPG http://www.***boat.com/image_center/data/524/3775DSC03060-med.JPG
RUSHIN ROULETTE
11-01-2006, 06:41 PM
What did you do, freshin it up? The tranny looks good..is it powder coated?
cole555
11-01-2006, 06:47 PM
The paint is just rattle can stuff used SEM brand with a self echting primer and base, tint and clear in 16oz can work ok ,I see how it hold up over time
cole555
11-01-2006, 06:57 PM
Lost a intake gasket,water in the oil and wiped out a couple of rods and the crank.
upgraded
callies crank
oliver rods
milodon gear drive
ATI dampner
8 mm pullies
used bds tall deck intake upgrade from a standard deck crager with spacers
manlely nextek springs
10* degree ret TI and TI locks
coated bearing cailco
coated the pistons did not hurt them
coated the cam it was ok to
new morso oil pump
new oil pump rod
new carter fuel pump also
new oil pan billet fabraction 14 quart
losts of new fittings that needed replacing
RUSHIN ROULETTE
11-02-2006, 04:11 PM
wow, lot's of upgrades..keep us posted on how she runs...