Switch Plate

[Schiada76]

I think I've asked this before but...
Does anyone know where I can get an AL rocker switch plate cover?
The one I have is beat to shit. It has "Start, Mag, Fuel and Bilge etched above each switch. I saw one awhile ago in a catalog but can't remember which catalog. Or does someone know where I can get one fabbed? The plate would be easy but I don't know about the labeling.

[GofastRacer]

There's quite a few that makes them but Painless has some cool ones!..
Painless! (http://www.painlessperformance.com/webcatalog.asp)

[Schiada76]

Thanks Art.
Those are close I'm probably going to have to have one made.

[GofastRacer]

Have you tried these guys???..
Eddie Marine! (http://www.eddiemarine.com/Cart/catalog.asp?CategoryID=86&CategoryName=Switch+Panels)

[LD Mandella]

I made mine for pull switches, same idea, any trophy place can engrave whatever you would like on the plate after it is fabbed up, I had the pull knobs engraved for my specific functions. Turns out to be a fairly inexpensive way to gat a nice cutom set-up.
Good luck
John

[Schiada76]

Thanks Art. I'll see if Eddie M can make me one.
If not I'll have Baot anchor make one and follow LD Mandella's advice.
Or..................I'll see if a trophy shop can do the whole nine yards.

[superdave013]

Boat Anchor makes nice stuff. Why buy the same thing everyone else has when you have his talent right there?

[Schiada76]

Boat Anchor makes nice stuff. Why buy the same thing everyone else has when you have his talent right there?
I was worried about the etching. I would talk to him first if I couldn't find one off the shelf (which I haven't). So I took LD's suggestion and will have Scott make me one and the trophy shop will etch it.
Thanks for all the input.