600.00 $$$$

[gabe1]

I have a CNC bandit, it needs work on the boards. Horizontal mill. Youi pick up 600.00 OBO

[SummitKarl]

I have a CNC bandit, it needs work on the boards. Horizontal mill. Youi pick up 600.00 OBO
any idea what the drives for the motors are and are the motors stepper or servo with tach and encoders or tach and resolvers
if the controller is bandit what is the machine...bridgeport?
is the power 220-1 or 220-3, 220-3 counts me out no residential 220-3 in havi

[gabe1]

Ill find out for ya/

[uvindex]

I have a CNC bandit, it needs work on the boards. Horizontal mill. Youi pick up 600.00 OBOSince there are folks on HB from all over the US (and even other countries) you might want to give the location where it needs to be picked up. :)

[gabe1]

Sorry Paramount, CA

[Baja Big Dog]

any idea what the drives for the motors are and are the motors stepper or servo with tach and encoders or tach and resolvers
if the controller is bandit what is the machine...bridgeport?
is the power 220-1 or 220-3, 220-3 counts me out no residential 220-3 in havi
NOT TRUE!!, run an inverter on the motor side, the control side is transformer driven from a single phase source.
The inverter can be run single source with a 3 phase output, most mills are less than 3 HP, means you could run it on a 5 HP inverter.
Or you could use phase converter.

[superdave013]

I have a Super Max with a Bandit control. It's making chips as I type. It's ok for what it is.
http://www.***boat.com/image_center/data/500/9DSC01864.JPG