wsm9808
02-19-2007, 10:12 PM
I'm making a little progress on the rail kit motor mount build. Its going a little slow because the wife also started a complete kitchin make over a couple of weeks ago too and its splitting my time and money between the two.
I have the final position of the stringer mounts set and the outer stringer support braces cut, drilled, mill slotted and mounted. Still need to decide on the final distance between the pump and crank flange and get a drive shaft built.
http://i133.photobucket.com/albums/q65/scottme/IMAGE054.jpg
http://i133.photobucket.com/albums/q65/scottme/IMAGE053.jpg
http://i133.photobucket.com/albums/q65/scottme/IMAGE061.jpg
I have the final position of the stringer mounts set and the outer stringer support braces cut, drilled, mill slotted and mounted. Still need to decide on the final distance between the pump and crank flange and get a drive shaft built.
http://i133.photobucket.com/albums/q65/scottme/IMAGE054.jpg
http://i133.photobucket.com/albums/q65/scottme/IMAGE053.jpg
http://i133.photobucket.com/albums/q65/scottme/IMAGE061.jpg