PDA

View Full Version : Art Carr Transmission Question?


SPECTRABRENT
02-21-2007, 09:02 PM
My trans does not have the converter, it has the Art Carr
adapter. How does this hook into the transmission?
Brent
GofastRacer
02-22-2007, 04:37 AM
The adaptor is just a converter without the insides, and it installs the same way!..
SPECTRABRENT
02-22-2007, 01:18 PM
I have Dave Sammonds rigging & installing motor & trans and he can not figure out this adapter.
Is Art Carr still in business? If so are they in Caiforrnia?
Thanks,
Brent
GofastRacer
02-22-2007, 01:42 PM
Ok, you have a Spline Drive it uses a Dampener Plate and you have to use a clutch type flywheel!.. I like the Hughes one better it just takes the place of the converter!.. Go to page 18!..
Art Carr! (http://artcarr.com/catalog.pdf)
Rexone
02-22-2007, 04:49 PM
Spline drive and HD dampener plate. (http://www.rexmar.com/page310.html)
Nailhead
02-22-2007, 07:59 PM
Hey Brent, I had the cheaper of the 2 in my 24 XS. When I pulled the engine last week I noticed all the springs around the plate were broken off. If you are making more than 600hp I would go with the more expensive of the 2. Those spring don't sound good when they go flinging off at speed.
SPECTRABRENT
02-22-2007, 08:31 PM
Hey Brent, I had the cheaper of the 2 in my 24 XS. When I pulled the engine last week I noticed all the springs around the plate were broken off. If you are making more than 600hp I would go with the more expensive of the 2. Those spring don't sound good when they go flinging off at speed.
I got the parts today.
Thanks,
Brent