Olsen Oil Cooler Question

[sawtooth]

I was looking at my olsen cooler and would like to mount the filter or filters remotley, does anybody know if there is an adapter made to do this that will mount to the Olsen cooler like the cooler mounts to the block filter location. Or should I just leave it like it is.....it would be so much nicer if the oil filter was in the open for service. Thanks for any help/info.

[Rexone]

You can use the STE410 pictured in the bottom left corner (http://www.rexmar.com/page277.html). It's billet and spins on to the chevy filter location (Olson cooler filter mount) as a source to take off to your remote filter mount (http://www.rexmar.com/page276.html).

[sawtooth]

You can use the STE410 pictured in the bottom left corner (http://www.rexmar.com/page277.html). It's billet and spins on to the chevy filter location (Olson cooler filter mount) as a source to take off to your remote filter mount (http://www.rexmar.com/page276.html).
Mike, will this go between the block and the olsen cooler or does the cooler go on the block and then the STE410 mounts up to the olsen cooler.

[Rexone]

Mike, will this go between the block and the olsen cooler or does the cooler go on the block and then the STE410 mounts up to the olsen cooler.
Cooler mounts to block as normal STE410 spins on cooler in place of chevy oil filter. One of the outer fittings gets plugged. It's just there so you can get a fitting on it depending on where it indexes when tightened.