Gil Replacement Flapper

[probablecause]

I have a set of Gil 4" angle cut exhaust tips and need to get a replacement flapper for one of them. I check Rexmar.com and cpperformance.com and they were not listed under the search. Any suggestions?

[AZLAW]

Cp performance has them Part 410-280173 or 410-280174. Part numbers for both the hypen is needed when you type them in.

[probablecause]

Cp performance has them Part 410-280173 or 410-280174. Part numbers for both the hypen is needed when you type them in.
Thanks, but I need the ones that look like this: http://www.cpperformance.com/detail.aspx?ID=357 I don't know if these will fit the 4" Gil exhaust or not. Brendan

[lakecrazy]

Are you running the Gil composite exhaust tips with the stainless steel extensions?
If so you are out of luck on factory replacement flappers as the composite tips were discontinued 3-4 years ago.
I bought a sheet of the high temp rubber used for flappers and cut my own, Worked great!

[Beer-30]

Your other option is to cut the slash off and make it a straight-tip. Then you could run the external ones:
http://www.trickmarine.net/images/productimages/ACF11A.jpg
If you like the looks of your slants and don't want to give that up, this option does not apply. :)