PDA

View Full Version : WANTED: Chevy motor for car application


Big Proppa
04-09-2007, 07:33 PM
something in the 3 to 400 hp range prefer 396 and up but 327 or 350 built would work also.
Machinist
04-09-2007, 08:45 PM
383 4-bolt late model roller block, Isky roller cam, scat crank, scat h-beams, AFR 195 heads, edelbrock air-gap manifold, moroso pan.
?
Where are you located and what are you looking to spend?
Squeezing Spectra
04-09-2007, 08:47 PM
Whatchu need Bill ?
BGMAN203
04-09-2007, 09:00 PM
Bill,
Check your pm.
Got a 400hp 350. 0 miles
Brian
obnoxious001
04-09-2007, 09:06 PM
I may have a 396 I can sell,, got someone interested in my Vega without the engine. Got 30 miles on it,, still in the car so you can see it run.
Big Proppa
04-10-2007, 06:38 AM
ttt
Big Proppa
04-10-2007, 01:03 PM
:d
Big Proppa
04-10-2007, 06:34 PM
:d
Big Proppa
04-11-2007, 06:18 AM
ttt
playdeep
04-11-2007, 09:38 AM
I have a 355 4 bolt roller motor,fresh, world product heads,jessel rockers,complete from k&n filter to aftermarket oil pan.
I can deliver it to Havasu anytime...$2000.00
my cell # is 505-620-7622,mychal
Blown to the Bone
04-11-2007, 09:53 AM
Got a 500 c.i.d. Cadillac engine complete ran great when we pulled it out.
$350.
victorfb
04-11-2007, 12:19 PM
whats in it now bill? small or big block? are you sure a big block will fit?
Big Proppa
04-11-2007, 12:39 PM
327 but its a ss 396 car - :D
469 the coyote
04-11-2007, 04:47 PM
I have a complete BBC ( less dist ) for sale. It has about an hour of run time on it. $3000
V-DRIVE VIDEO
04-12-2007, 10:25 AM
Bill,
I'll make you a great deal on a wounded motor. I was cruising about 35 mph and it started to make a tapping noise then it went away for about 30 sec came back up and the motor died. It would turn over but not real fast. I haven't cracked her open yet. Its a 396 with a 10.5 to 1 piston .40 402 pistons. 4 bolt mains and obviously steel crank.
The block is 3855962 and heads are large oval 3964290.
I also have a couple of sets of 990 heads and a used but good roller cam, 3 tunnel rams and a set of 600's and 660's.
The valve covers, scoop and distributor are not for sale.
Call or pm if your interested in anything (909) 466-1743
http://www.v-drivevideo.com/jerrysgallery/albums/userpics/DSC01485.JPG
http://www.v-drivevideo.com/jerrysgallery/albums/userpics/DSC01484.JPG
Big Proppa
04-12-2007, 01:10 PM
:)