bzking
08-01-2007, 04:28 PM
545 in. BBF, less 2Hr. time on this engine, sold the boat and dont need the engine.
1. upgraded eagle steel crank
2. forged probe pistons
3. H beam Rods
4. studded Block
5. solid roller cam
6. dv3 factory ford heads, studs, guide plates, 1.73 roller rockers,stainless valves, stud girdles (all new)
7. engine with these heads combustion chamber's is at 11.1 comp. ratio
8. Motorsport dist. (made by MSD)
9. Polished tunnle ram.
This motor has not been on a dyno but estimate h.p. around mid 500 mark, use aftermarket heads and this engine will reach some very respectable numbers, call me @ 858 530 2742 or email me @ kcc1622@aol.com
asking 3k for all.. thank you Keith
http://i182.photobucket.com/albums/x20/zingko2/IMGP2302.jpg
http://i182.photobucket.com/albums/x20/zingko2/IMGP2303.jpg
1. upgraded eagle steel crank
2. forged probe pistons
3. H beam Rods
4. studded Block
5. solid roller cam
6. dv3 factory ford heads, studs, guide plates, 1.73 roller rockers,stainless valves, stud girdles (all new)
7. engine with these heads combustion chamber's is at 11.1 comp. ratio
8. Motorsport dist. (made by MSD)
9. Polished tunnle ram.
This motor has not been on a dyno but estimate h.p. around mid 500 mark, use aftermarket heads and this engine will reach some very respectable numbers, call me @ 858 530 2742 or email me @ kcc1622@aol.com
asking 3k for all.. thank you Keith
http://i182.photobucket.com/albums/x20/zingko2/IMGP2302.jpg
http://i182.photobucket.com/albums/x20/zingko2/IMGP2303.jpg