PDA

View Full Version : Aftermarket Cylinder Heads 2.5 Merc.



737jetmech
12-05-2001, 11:37 PM
Anyone have aftermarket cylinder heads on 2.5 merc. 260 H.P.?Have you seen any performance gains?I do not want to raise compression ratio to the point of requiring race fuel.

Unloaded Racing
12-06-2001, 04:45 PM
Do you have any idea what cc heads you want? I have a set of 28cc done by Jay Smith if you are interested.
Tim

737jetmech
12-07-2001, 07:47 AM
Hey' Thanks' Unloaded Racing for your reply.I need to find out what cc heads I have on a stock engine first.I realize that compression is h.p..I still want to use 93 octane fuel.I use the boat for pleasure but looking for more speed.Runs 90 mph on a 21 Liberator with 26 Masco RE4 at @ 7100 rpm.

Unloaded Racing
12-08-2001, 06:34 AM
If your motor has the Factory stock heads they should be 37/38cc. Some of the Factory Mercury Heads are stamped on the side of the top corner. The cc of the heads can also be checked after removal with a syringe and water. Most Lakers run 28cc up. I ran the 28's on Mirage River Racer with a STOCK 2.5 carb motor and the boat ran 83-85 mph in the Quarter Mile. Let me know if I can help.
Tim

Scaryfast
12-20-2001, 08:36 AM
28CC is way too tight for 93 octane though. To be safe you should be in the 32 CC range at a minimum. I have had a set of Wizard aftermarket heads. They're about 5 hp stronger than the standard merc heads at identical CC. I'm not sure they're being made anymore though.
Milling them will give you a little more punch, but won't make a drastic improvement in top end speed.
Sam Baker
Baker Marine Support http://www.scaryfast.com
rbakerjr@scaryfast.com

737jetmech
12-22-2001, 01:09 PM
Thank you Scary fast. I just don't know very much about out board power plants and your information helps a great deal. Most folks in are area run I/O or Jets drive stuff.I also have talked to Chuck Goodman at Nitrox Injection Systems about Nitrous Oxide.His system sounds good in theory and design but not sure if the motor will live! N.O.S will give me the most bang for buck.I just need to do more research. Thanks again for your reply.Jetmech over and out!!!!!!