PDA

View Full Version : Jack Plate



kwest53
08-30-2001, 05:48 AM
I'm looking for a low buck jack plate (probably manual not hydraulic) for my '81 American Multicraft Tunnel with a 175 HP Merc.

corm
09-02-2001, 08:36 PM
Hi,
These people make a good one.
www.cook-mfg.com (http://www.cook-mfg.com)

kwest53
09-04-2001, 08:57 AM
A used manual jack plate with no more than a 4" set back is what I'm interested in. I will raise the 175 HP Merc just one time to the correct position and then never move it again. I need raise the outboard between 3 and 5"

HavasuBarney
09-05-2001, 01:10 PM
You can try Chuck Goodman 318-965-0201
They make Rapid Jack set back plates, manual, no motors, lots of possible configs. can add neg trim, etc...
Another place would be www.screamandfly.com (http://www.screamandfly.com) classifieds.
May even be easier to design your own, I have some great setback pictures I took at a boat show and on many outboards I was looking at when I designed mine. Email me and I'll be happy to share some pics with ya.
http://images.webshots.com/icache/co/18/39/19631839VtjgWlysmBthumb.jpg---http://wsphotofews.excite.com/028/vU/3y/R4/8Q17221.jpg
[This message has been edited by HavasuBarney (edited September 05, 2001).]
[This message has been edited by HavasuBarney (edited September 05, 2001).]