Carb leaking. Where do I get these things.

[socalmoney]

Where do I get these little plastic gaskets that are on the screws for the float bowl. Mine are leaking. What are they called so I can google them. Don't see them on Holley's website. Could there be another reason why they are leaking. Will new gaskets solve this?
http://www.***boat.com/forums/attachment.php?attachmentid=39406&stc=1&d=1190081148

[wolfie]

They come with a carb kit. You can get them anywhere. It's the Float adjust gasket.

[Cs19]

you need the needle and seat gasket?
I think they come with a needle and seat kit.

[AZKC]

Lose the plastic and go copper washers:)

[socalmoney]

Found it. Thanks guys. Those stupid things keep me from boating this last weekend. Motor fired right up for me. Didn't even make it off the trailer when I saw that leak.
1008-776 Needle And Seat Top Gasket
For All Holley Carburetors with Adjustable Needle and Seat
1008-777 Needle And Seat Bottom Gasket
For All Holley Carburetors with Adjustable Needle and Seat
Where do I get copper?

[socalmoney]

Where does the O ring in this photo go. I didn't see one when I pulled mine apart.
http://www.holley.com/data/products/pictures/large34-7.jpg

[Cs19]

The o-ring goes on the needle and seat body, Ive had them go bad before, not a bad idea to change them.

[socalmoney]

The o-ring goes on the needle and seat body, Ive had them go bad before, not a bad idea to change them.
Could a bad O-ring cause an external leak? Do I have to back the float adjustment screw all the way out to change it? I am looking for an exploded view of this online and I can't find one.
found some
http://www.holley.com/TechService/Library.asp
http://www.holley.com/data/TechService/Technical/4150-4160%20Exploded%20View.pdf
http://www.holley.com/data/TechService/Technical/4500%20Exploded%20View.pdf

[78Southwind]

I had small threads come off of my needle a seat because of my chrome bowls. They ended up going between the O-ring and the needle causing a bowls to over flow and leak externally.
http://www.***boat.com/image_center/data/500/1676Needle_Seat_Threads.jpg
http://www.***boat.com/image_center/data/500/1676Needle_Seat.jpg
http://www.***boat.com/image_center/data/500/1676Bowls.jpg

[socalmoney]

Sounds like I should take the float bowls off and investigate.

[Cs19]

No, just loosen the 5/8 nut and thread out the whole assembly, change the o-ring and re-install. Check to see that there is no debris where the needle seats in the body. A bad o-ring or stuck needle from debris will cause leaking.
Could a bad O-ring cause an external leak? Do I have to back the float adjustment screw all the way out to change it? I am looking for an exploded view of this online and I can't find one.
found some
http://www.holley.com/TechService/Library.asp
http://www.holley.com/data/TechService/Technical/4150-4160%20Exploded%20View.pdf
http://www.holley.com/data/TechService/Technical/4500%20Exploded%20View.pdf

[RCB19]

Cs&J19 Engineering.