Can someone run these Numbers for me on Desk top Dyno?

[FoMoCo]

Can Someone with Desktop Dyno run the numbers again for me using the flow chart below (For Edelbrock RPM 460 Heads).
The motor is as follows:
460 Ford Bored .080 over (=477 CU)
11:1 Compression (SRP Flat tops with 2 valves relief’s)
Scat H-beam Rods
Balanced Ass.
Cam is Comp Cam 300AR Solid Roller
(.663 lift 262 Dur@ .050 110 Lobe Sep)
Heads (Aluminum Edelbrock RPM with 2.19 intake valves & 1.76 exhaust)
Weiand Tunnel Ram with (2) 750 CFM Holley DP’s
Rewarder Open Headers
I want an Honest 600 Hp , I hope I can make it!!!
.100”
Intake/Exhaust
76/67
.200”
Intake/Exhaust
140/118
.300”
Intake/Exhaust
207/153
.400”
Intake/Exhaust
260/180
500”
Intake/Exhaust
300/200
.600”
Intake/Exhaust
319/207
.700”
Intake/Exhaust
326/207

[beached 1]

If you can give me the exact specs from your cam card, I can help you.
I've got the int lift and Exh lift but I also need
IVO (BTDC)
IVC (ABDC)
EVO(BBDC)
EVC(ATDC)
when i punched in your numbers and guessed the items listed above it puts you a little above 600HP.

[FoMoCo]

Thanks, I have the cam card at home, I will post those exact numbers when I get there!!

[Dog]

If these are close to your cam numbers heres the numbers.
.663 lift intake and exhaust
300 intake and exhaust duration (Advertised i believe)
IVO 40
IVC 80
ECO 80
EVC 40
110 lobe centers
http://www.***boat.com/image_center/data/500/292screenshot_002.jpg

[beached 1]

I cam up with about same as Dogg yesterday