rail kits

[Just Electric]

looking for some companies other than lightning that make a nice rail kit for jet boats

[396_WAYS_TO_SPIT]

Try Tom @ jetboatperformance.com or hi-techperformance.com
Why dont you go with lightning? Too exspensive?

[jrork]

Iff'n you don't want a already polished shiny set up, there are two options that I know of,
Like Mike said, Tommy at JetBoatPerformance has all the peices waterjetted to fit like a glove and you can finish them to your tastes (this is the way I went).
Or
Duane at Hi-Tech has a kit as well that I believe you can get unfinished.
Either folks will do you right......good luck....john

[Just Electric]

thanks for the help i will look into it. my project boat has a wide stringer configureation. 26 1/2 inches apart are the stringers, plus i want to put it on angle iron so i can take the back seat out and push the motor a little more forward and go racen.

[Just Electric]

thanks duane at htp for your pm.

[Duane HTP]

Sure, Our plates come 27" wide so you can cut to your desired width. We make them in house, so we can cut the angle rails whatever length you may want.

[Just Electric]

Sure, Our plates come 27" wide so you can cut to your desired width. We make them in house, so we can cut the angle rails whatever length you may want.
nice i likey thanks for the help hopefully be purchaseing the kit from you soon

[HawaiianJet]

Damn, I still like that avatar!!!!!!:jawdrop:

[Just Electric]

Damn, I still like that avatar!!!!!!:jawdrop:
why thank you:)

[HawaiianJet]

My bad, I meant the sig line!:D Butt the avatar is nice too.:D