455 Berkeley water logs

[SeaSlut]

I have discovered my right water log is weeping water. Apparently it must have froze and was ready to crack. Bad JuJu.
Anybody have any luck welding these?
Anybody have a set to sell?
for 455 olds, thru hull.
[ May 02, 2003, 12:21 PM: Message edited by: SeaSlut ]

[1973 Hondo]

I have a set , they have been welded but do not leak, replaced them with chrome ones. If you are interested let me now, ill let them go pretty cheap.

[sidewound]

Mine were both cracked. I had some duffuss weld em and they broke again in an hour. If you do get it welded make sure it's heliarced. Mine were spoolgunned. I ended up buying some used hardins for a buck and a half. Good luck!
Peace Man
CESAR

[HalletDave]

Sidewound,
Did you make a decision about the diverter we were dicussing? I hope things worked out good for you.
HD

[Jim Brock]

I have a set, call Jim (818)890-1867

[Tahiti Owner]

OK where were you guys with the logs when I drove out to So Cal and back last week????? I needed a set too! I have the same situation with a small crack from a winters freeze!

[SPECTRABRENT]

I have a set of 455 Olds logs with risers.
If you need spare 455 Olds complete motor (carb to pan), I have that too.
I will beat all deals on the board.
Brent
818-621-5626

[Charger455]

I have a 455 engine mount set. Not sure of the type. I also have a set of aluminum finned hardin marine valve covers for a 455. I will let em go for cheap too!!!

[GlastronGuy]

Charger455:
I have a 455 engine mount set. Not sure of the type. I also have a set of aluminum finned hardin marine valve covers for a 455. I will let em go for cheap too!!! Could you post a pic of the covers?

[Charger455]

Glastron Guy;
I'm working now, give me a few hours cause I actually have 2 sets. I need to take pictuers and then post em. I will try to get to it this afternoon.