LOOKIN FOR A SMALL BLOCK 350

[DICK THORPE]

Hey group
I'm looking for a Chevy 350cu.in. block needs to be late model 86 or later also it needs the bosses in the valley for the spider for roller lifters.
Four bolt is ok but not necessary my tow rig needs an up grade badly.
Thanks Dick Thorpe
702 645 0840 (Las Vegas)
rslt@lvcm.com

[Jungle Boy]

DICK THORPE:
Hey group
I'm looking for a Chevy 350cu.in. block needs to be late model 86 or later also it needs the bosses in the valley for the spider for roller lifters.
Four bolt is ok but not necessary my tow rig needs an up grade badly.
Thanks Dick Thorpe
702 645 0840 (Las Vegas)
rslt@lvcm.com Have you thought about a ZZ4 crate motor. We know lots of guys with them in boats and just lately a buddy put one in his truck and it is GREAT.

[jim lee]

Dick Thorp,
Didn't you have a Tahiti? Plumb Crazy? I seem to recal in my foggy memory..
-jim lee

[75spectra]

I have a completely rebuilt factory rollor cam smallblock for sale. Bored .030 with new cast 9:1 pistons, .010/.010 crank (fully balanced), Callies 3/4 groove main bearings, all naw valve train including a GM (14097395) roller cam. Fresh heads (not vortec) but center 4 holes are canted. This is a complete engine less manifold and balancer. Only has 3800 miles on it. Have pictures upon request. $1500.00 but freight would be harsh from ohio.

[DICK THORPE]

Hi Jim
I still do have a Tahiti LX 19 named Plum Puddin.Been watching your posts.
The zz4 is not to be fuel injected as far as I know without extensive computer mods, however T.
P. I Spaeialties is more than capable of doing it I'm not in 10:75:1 cr gas is expensive enough without buying 91 octane.
The other block sounds however to complete I'm doing a 383 strocker that my comp can controll very nicely with the stock chip unless............
Thanks guys just need a re buildable 350 block
Dick Thorpe

[v-drive]

Dick, I have a block in my garage that I have had since the late 80's. Reath automotive did the machine work but I'm not sure of the galley area so you will have to wait until this afternoon
before I can look at it. :cool: v-drive

[Tee]

Dick,
I have a block. Needs to go 40 over to clean it up. Has been clearanced for either stroker or H-beam rods. Also have a roller blower cam roller lifters and the spider tray that holds it all in place. Oh, and I have a forged 1 piece crank too.
Let me know if you are interested.
Tee

[DICK THORPE]

Tee,V-Drive;
Both blocks soud good let me know.
Again my Ph. # 702 645 0840
rslt@lvcm.com

[v-drive]

Dick, I was just out looking and I'm guessing it's pre 86 as there are no bosses in the valley.
Damn I wanted to sell that thing.
:cool: v-drive

[DICK THORPE]

V- Drive;
Thanks for the look.
Dick Thorpe

[21rayson]

i have a 1990 complete 350 it came out of a van if interested.