Looking for Hawaiin badges...

[al cole'holic]

...anyone have a set of these in good condition? :D

[spectratoad]

Here is a set. Sorry had to be a smartass. :D :D
Wasn't RRX or roostwear doing these? Maybe those were decals. I don't remember.
http://www.***boat.com/image_center/data/520/307hawaiiBadge.gif
http://www.***boat.com/image_center/data/520/307hawaiiBadge.gif
[ August 21, 2003, 07:39 AM: Message edited by: spectratoad ]

[roostwear]

I do them in vinyl, but as far as reproducing them in plastic or pot metal, that's a little pricey. If someone knows anybody that can do low volume sand or plaster casting, let me know.

[AZKC]

Like these :D
http://www.***boat.com/image_center/data/500/57Hey_Babe11.jpg
OldGuy was setting up a shop this summer, he thought he might be able to reproduce some in cast. The originals I have on my boat are plastic and getting in bad shape.
KC

[roostwear]

That project is in the works, I'm thinking of using a resin-based material instead of injection molding or pot metal.

[roostwear]

DOH!
[ August 21, 2003, 03:34 PM: Message edited by: roostwear ]

[1Bahnerjet]

[QUOTE]Originally posted by AZKC:
[QB] Like these :D
http://www.***boat.com/image_center/data/500/57Hey_Babe11.jpg
Hey AZKC, Nice set of Badges you have in your Boat, Oh I mean on your Boat :D
---------
Thats BANNER with an H

[Old Guy]

I am going to try to make some metal emblems. There is a process that I am familiar with that involves a metal that has a relatively low melting point. It's kind of expensive but emblems shouldn't require very much. Plating could be a problem. The only custom plating I've had done was some small bow lights that I made for an antique boat. That guy had a $50 minimum and that was 18 years ago. Possibly buffing and a clearcoat would work.
My new shop will be up and running in a matter of weeks. I expect it will be a very interesting project.
old