lube for the pump. where?

[jboehm]

i have found the grease fittings for the coupler from motor to pump. what other places need grease or oil. what type to use. i am new to jets, can't you tell.

[Danhercules]

Here is an old thread of the same question. http://forums.***boat.net/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=11;t=002591
If that dose not work, Its on page 9. The last page was on May 1st.
Glad to help.
Nice to help someone in return!! :D

[stonehedge]

That topic answered about 99% of all my questions, but one. Is there a drain plug for the gear oil, and if so does it need to be drained or flushed for maintance reasons? Mine doesn't leak or need much added, but wondering if it needs "more" service than just adding?

[Taylor LP]

The drain / fill plugs are on the top of the bowl at 10 & 2 o'clock.(see the pic in that thread) Remove both plugs. Pump it in either one till lube comes out the other. If your changing instead of adding, keep pumping until the lube comes out clean. Usually the old lube will be a little cloudy. Easier if you get a couple of 1/4npt barb fittings and clear hose from the hardware store.
[ June 03, 2003, 07:07 PM: Message edited by: Taylor LP ]