Mach I tunnel for sale

[e-ticket]

This project is for sale! Hull is lightweight (375lbs). Fresh paint with blue and gold pearl in the clear coat, rail kit and motor mounts (454 Chevy), alum tanks, pump (bayjet -berkley shoe), drive shaft and power takeoff, upholstered fiberglass bucket seats, ride plates and alum deck supports. This was an early 80's one of a kind dragboat (no paperwork). The trailer was completely redone with stainless fenders, new low profile 50 series tires, Ultra wheels, fresh paint, wiring, and lights.
Am asking $1700 obo for it.
I really need to make room! BAD :(
g.breid@verizon.net
805-482-8799
http://free.***boat.net/ubb/Avatars/Reader_Rides/Jet_Boats/PC280076-11.JPG
[ January 25, 2003, 04:47 PM: Message edited by: e-ticket ]

[MikeF]

Could be a Wildercraft?

[e-ticket]

It was made by Auto Marine Engineering in Upland, Ca. It would make a nice boat for river racer.
I really want to move this to make room for another boat. I have alot of $$$ in this and ready to let it go very cheap. cry

[Jake W]

So it is a tunnel do you have any pics of the back of it?Jake

[e-ticket]

http://free.***boat.net/ubb/Avatars/Gearhead_Garage/Other_Equipment/tunnel.JPG
This is the only pic I have of the back (when I was painting it).
There are ride plates that fit on the tunnel portion with turnbuckles to the transom. They are being polished.

[Raskal]

nice lookin boat is it a 2 seater or 4

[e-ticket]

I presently have two fiberglass buckets (black upholstery). You might be able to fit back to back buckets for four, but it might quite a bit for the boat, since it was really a drag boat.

[e-ticket]

Sold! :)