Blower cam?

[Kindsvater Flat]

I'm stuck here. What I have now in the tunnel ram motor is 274/276 @ .050 .620 lift 110 center
What do I get? Compression will be a little over 8:1 with 8lbs boost.
Forgot this is a 440 chrysler, ported alum heads.

[GofastRacer]

Just going by what you say, you need more lift to pass the air and go for 114 centers so not to lose the boost on overlap!....

[Kindsvater Flat]

How much lift? Duration?

[GofastRacer]

If you're going with a solid cam I'd get the highest lift I could find, with a roller .700 at least, duration depends on rpm's you plan on running?, 7000+ 270 range is good!....

[Kindsvater Flat]

I sent a email to Scott Brown of straightline.com. He is some type of mopar god. I never heard of him but thats who was recommended in the mopar boards.
Once I get the numbers I will post them up.

[Infomaniac]

I missed it last time you asked.
Those Mopars take a ton of duration.
I am interested to see what the Mopar Gods have to say.

[Fiat48]

If you can get someone to flow test the heads or if there are some flow specs available, we can run it through the cam program and see what it says.

[GofastRacer]

Well since I'm not a Mopar guy, I'm interested in hearing what the gods have to say about it too!..:)

[Kindsvater Flat]

Spectra Squeezing would be the one to ask about the flow numbers. They belonged to him.