holley carb parts question?

[phegan]

hey folks, I have a couple of used carbs(I only need one) there is a few things i can't figure out. First: I bought a (so-called) used marine carb,
but one of the j tubes is broken .Where can i buy a new j tube ? Also, the number stamped on the horn looks like some weird OEM number so i can't figure out what the cfm's are and what rebuild kit to get.( here are the
numbers )(it has vac/sec)
E9JL-ea
50470 2686
second:The second carb i know a little more about, but not much.
stamp on horn= 4777-22175
this is a 650 dp with mec/ sec's with manual choke.
thanks guys

[Squirtcha?]

carb model number 4160
650 cfm vac secondary
primary needle and seat 6-516
primary main jet 122-74
primary power valve 125-65
primary discharge .040
secondary spring (pink)
rebuild kit # is 703-33
trick kit #N/A
Or so the book says.
Not sure where you could find a J tube. There are some guys that post here that could probably tell ya.
If I'm reading this right, the second one is
carb model number 4150
650 cfm mech secondary
primary needle and seat 6-504
primary main jet 122-67
primary power valve 125-65
primary discharge .028
secondary spring or nozzle (.028)
rebuild kit #37-485
trick #37-910

[Hotcrusader76]

I carry the Marine J-tubes here at TPC. If ya need one give me a call on Monday.
Note- If that J-tube broke off you need to pull it out. Drilling it out will be near to impossible. Trust me! Try to yank it out by twisting it back and forth with some vice grips. Drilling it will not be an option.
Hope that helps some.
BTW- Those carbs are 650cfm versions. I would stick with the 4777 version and add J-tubes. The Marine carb is junk for performance.
~Ty
877-TPC-CARB

[phegan]

hotcrusader,I'll definately give you a call on monday. I was secretly hoping you would respond to this post;)
J tubes seem to be harder than hens teeth to find.
who should i ask for? Hot ? or Mr Crusader.
btw, this carb is going on a very mild ford 460, so i think it will do nicely.

[phegan]

thanks Squirtcha, big help. I wrote those numbers down in the holley book that i have.( it's kind of sparse in the detail department )

[Hotcrusader76]

Originally posted by phegan
hotcrusader,I'll definately give you a call on monday. I was secretly hoping you would respond to this post;)
J tubes seem to be harder than hens teeth to find.
who should i ask for? Hot ? or Mr Crusader.
btw, this carb is going on a very mild ford 460, so i think it will do nicely.
Ask for Ty:D and mention that you're from ***boat...It helps:D