does size really matter?????

[SANGER-RICH]

How close is the closest you can be on a v-drive from the prop to the bottom of the boat?. 1" 1.5" 2"?????

[Lookin for Liquid]

Are you referring to a flat or ski hydro as in the picture?

[79 Howard]

I did a prop with harold kindsvater and after the final cut he had me at a 1/2 in from the bottom[about your finger width] it was really scary and caused too much vibration from prop wash so he cut it another 1/8in:eek!:

[SANGER-RICH]

Originally posted by Lookin for Liquid
Are you referring to a flat or ski hydro as in the picture?
The one in the picture.

[SANGER-RICH]

Originally posted by 79 Howard
I did a prop with harold kindsvater and after the final cut he had me at a 1/2 in from the bottom[about your finger width] it was really scary and caused too much vibration from prop wash so he cut it another 1/8in:eek!:
So a minimum distance would be 5/8" , is there to much or does it matter for a hydro blowing the tail.

[Sangster]

Sanger-Rich...That boat came with a strut installed and holes for where the v-drive goes didn't it??.... Jest be sure that the back side of the prop is no further than 1/2 " away from the strut barrel & you will be fine.....Run the prop you got with the motor you got for now.....Your HP dictates the prop/gear size.......

[Sangster]

Rich.... Get ahold of Tom Bentley up in Auburn, Tell him what you got & he'll set you up the right way....;) ;)

[78Eliminator]

Good question. I was thinking about this exact question driving home from work today......

[mfrey]

Originally posted by SANGER-RICH
How close is the closest you can be on a v-drive from the prop to the bottom of the boat?. 1" 1.5" 2"?????
Mine is 2" Rich...11 1/8" x 16" 3 blade