Pump Shaft ??

[502 JET]

I have a Dominator 12 S pump.The shaft has .001 run out in the center when clamped in a lathe and checked with a dial indicator.Also where the bowl bushings ride it is worn to 1.120 from 1.122.Is this shaft servicable like this or will it need repair?Thanks for any help. Mike

[TIMINATOR]

Polish it where the bowl bearings ride, replace the bowl bearings and you are good to go. If the wear was severe, there is a repair sleeve for the bowl end of the shaft, we do these all of the time. No problem. TIMINATOR

[396_WAYS_TO_SPIT]

tim is on the money;) Thats what I would do;)
396

[502 JET]

Thanks guys!I already polished the shaft when it was in the lathe.I just need to order the parts to put the pump back together. Mike