PDA

View Full Version : Hyd Place diverter ?


Taylorman
05-31-2004, 12:43 PM
What AN size are the fittings that go through the hull for the hyd place diverter lines?
AmericanThunder1
05-31-2004, 02:58 PM
Mine takes a 1/2" wrench so that would be what? 7/16"? The line is 1/4" I dont know exactly what you mean by AN size.
FOURQ
05-31-2004, 05:54 PM
the fittings on the pump and cylinder are 1/8 in pipe threads ... i just did mine in -4 an tube ( not hose ) and i just used an 1/2 in cord clamp like you would use on the s/t control cable to seal it.. i will get you a pic if you need one..
4Q
Taylorman
06-01-2004, 05:41 AM
Originally posted by FOURQ
the fittings on the pump and cylinder are 1/8 in pipe threads ... i just did mine in -4 an tube ( not hose ) and i just used an 1/2 in cord clamp like you would use on the s/t control cable to seal it.. i will get you a pic if you need one..
4Q
Pictures are always good.
FOURQ
06-01-2004, 06:12 AM
i will take some later today
FOURQ
06-01-2004, 09:30 PM
http://www.southwindjetboats.com/pump2.JPG
http://www.southwindjetboats.com/pump1.JPG
http://www.southwindjetboats.com/pump3.JPG
http://www.southwindjetboats.com/pump4.JPG
there hope this helps you see what i did and solves your question problem..
4Q
flat broke
06-02-2004, 10:01 AM
Another way to do it is to use -4 AN hose to a -4 AN bulkhead fitting sealed with o-rings at the transom, then -4 AN on out to the bimba cylinder. Hacker runs that setup and it doesn't leak at all. BUUUUt the -4 bulkhead fittings cost more than those cable clamps, and you'd have to buy 4 more hose ends than the way that Four Q suggested.
Chris
Mohavekid
06-02-2004, 08:02 PM
Rex and CP Performance sell a braided line kit that comes with the lines pre-made and the bulkhead fittings in stainless.
www.rexmar.com/page129.htm
http://www.cpperformance.com/detail.asp?product_id=151-25132
These kits are about $135.
FOURQ
06-02-2004, 08:31 PM
mine cost about 50 bucks total.. talk to superdave013 he will hook you up on the fittings
novaguy
06-03-2004, 12:13 AM
What AN size are the fittings that go through the hull for the hyd place diverter lines?
Taylorman,
I just did this with my boat. The size you are looking for are
-4an. I bought special long stainless steel bulkhead fittings from Rex (I think they get them from Cherry) they are $20 each. Used (2) 90 degrees
-4an to 1/8' pipe fitings for the cylinder and 1/4" pipe to -4an for the pump. I used all stainless fittings and -4an braided stainless hose premade at Bonaco. try www.bonacoinc.com
Good luck,
Rob
http://www.***boat.com/image_center/data/500/351DSCF0178-med.JPG http://www.***boat.com/image_center/data/500/351DSCF0177-med.JPG