Recommended Push Rod Length?

[Shallow Minded]

Any ideas on what I'll need for push rods with this set-up?
Gen V BBC 454, standard deck with factory GM heads (casting #14097088). Using a Crane retro-fit hydraulic roller cam (CRN-139731).
I've gotten a few differing lengths from the various tech lines and was hoping to get a consensus from the guys who really know.
3/8", .080 wall thickness... just looking for the proper lengths to insure my geometry is OK. Thanks.
SM

[Infomaniac]

Just buy the standard hydraulic roller push rod set and check them. Rarely are they in serious need of a lenght change.

[Shallow Minded]

Thanks, Info. That's kinda what I was hoping to hear. If they're way off, then I guess I'll need to adjust, but the standard GM's seemed to work just fine. I'm just looking to upgrade with a thicker wall, etc.

[Nucking futs]

I just upgraded mine with some manleys and they measured 8.600 and 7.650 and then i checked them on the valve and they were perfect.