Well being you said!!

[Jr. bentpipes]

I can show you the damage, not to bad even if I did screw up here bung!!
http://www.***boat.com/image_center/data/524/1492MVC-009S-med.JPG http://www.***boat.com/image_center/data/524/1492MVC-001S-med.JPG http://www.***boat.com/image_center/data/524/1492MVC-007S-med.JPGhttp://www.***boat.com/image_center/data/524/1492MVC-006S-med.JPG

[Jr. bentpipes]

http://www.***boat.com/image_center/data/524/1492MVC-005S-med.JPG
And here it sits until I get off my big ass and get it done, I am looking for you hired bung!!!!!!
Any ways, any of you stack injector guys know anything different you would want in a cam,being that we do not have a plenum? Is there a duration you want to look for etc. Any info would be appreciated!!!!:)

[Fiat48]

You may be able to just emory cloth that cam lobe down. Roller cams are pretty tough.
What caused this?

[Jr. bentpipes]

To be Honest I think I left that one a little loose, and I think my pushrod length is on the short side for good geometery.

[Jetboatguru]

Note to Jimmy,
When motor is sounding and running like DOO DOO, shut it off and get towed in before you make 3 passes with it. As far as the cam goes, 118 lobe center 980 lift 292/320 duration. That ought to be a good one.:D

[FLYTE RISK]

That particular cam shaft sounds like a winner J.R.B.P;)

[smalls]

JR, I have a used set of roller lifters and a pushrod stretcher if ya need them..