Holley 3310 Idle Bleeds

[EASYSTROKE]

I'm putting together a holley 3310 vac secondary to do some testing with. It has adjustable air bleeds on the front side idle circuit but the air bleeds are missing. I am going to make some more but I need to know what size the holes in them should be to start with. I looked on holley's site but couldn't find anything. If anyone has a holley tuning book, it may be in there. Idle circuit on the primary side of a 3310 750 vac. secondary carb. Thanks for any info.

[Petrofied]

Hotcrusader 76 will have the answers you need. He's always willing to help. :)
MR.P.

[Hotcrusader76]

The basic settings are as follows:
Idle Air bleed- 0.073"
High Speed Air Bleed- 0.035"
If the carburetor has four corner idle then it's the same on the secondary as the primary for basics. If it's two corner idle then the the Idle Air bleed should be around 0.045".
Call me if ya need anything.
~Ty

[EASYSTROKE]

I called Ty ( Hotcrusader76) just to make sure that I was on the right track and he is a super nice guy and was very helpful. The world would be a better place if more people were like him. Thanks again Ty for the help.