-
You can do up to 4 10" subs behind the seat w/o modifications to the seat all amps are under the seat w/o modifications.
http://www.***boat.com/image_center/...re_020-med.jpg
We also have moved the rear speakers from behind the seat to in the doors.
http://www.***boat.com/image_center/...re_019-med.jpg
Both of these will look as close to factory as possible, If you were interested in doing something more extreme let me know I can post some pics of that too.
-
Hey... this is kind of blue sky but think about this...
You could try running fairly high Qts poly cone drivers mounted on the floor of the truck firing down with the outside world providing the infinite baffle. You would lose a few dB when you roll down the windows.
You'd probably want to shield the cones a bit from road hash but it wouldn't take too much. You could even hang the baskets under the truck if room were a problem and the truck lifted high enough but then you might get trash in the spiders and such if they aren't shielded sufficiently. I think it would be a pretty slick infinite baffle solution.
I'm actually serious on this one...
Any response? :D
It does work. I had a similar setup in one of my show cars where the mids were mounted in the floor up front with a set of USD waveguides for the highs it sounded really good. Most people dont want to cut up thier car like that though. Too bad because it was one of the best sounding cars I have ever built.
-
If you were interested in doing something more extreme let me know I can post some pics of that too.
I'd consider it a favor if you would post those pics. :)
Thanks for the pics you've already posted, BTW. :cool:
-
-
Yes, we will either have to relocate the power motor or only do 3 10's. I would have to see the truck.
-
it was one of the best sounding cars I have ever built.
We did USD Waveguide components in the early 90's. The vehicles we used them in were some of the best sounding vehicles we ever put out.. Seemed like everyone with a cutlass, bronco, or probe wanted them ;)
-
I still have a couple sets of them that I am saving for a project.
-
I still have a couple sets of them that I am saving for a project.
I don't have a set saved, but I do have plans to call Eric for a set ;)
-
Bring it over here. Well put a body lift on it, completely cut out yout floor and add 7 inches of depth put a sub floor in. We'll put 8 Boston pro 10's in the floor, put 2 pair of components in each door in completely custom panels and put 6 amps in the rear. 3 on the rear panel then the other 3 built into the back of the rear seat. I'll motorise all of your saets to lift and flip in order to expose the floor and rear seat amp area. What about the dash you say? you don't need no stinking dash. We'll fab a new one that completely sizes and retracts(clusters, pedals, and controls move) when you push your button on your alarm remote upon entering the vehicle. All Alpine F1 status gear with a full surround sound.
I'll get Charlie to help out with the interoir lighting ;D
When you wanna drop it off?
Uhhhh ..... To far on that one. :D
-
Where's your sense of adventure? :D
HAve your neighbor kid to it :idea2: