-
I have some used parts.....
Torker 460 manifold with carb spacer (pic below...)
http://www.***boat.com/image_center/...41IMG_0552.JPG
Mallory Distributor with 9.5 mm MSD plug wires:
http://www.***boat.com/image_center/...41IMG_0561.JPG
Hardin Marine timing chain cover:
http://www.***boat.com/image_center/...41IMG_0554.JPG
http://www.***boat.com/image_center/...41IMG_0553.JPG
I was thinking that somewhere around $175- was fair for the whole deal...I will ship FEDex ground - on the west coast-Az. etc., its very reasonable and will probably be less than $10
Or, if someone wants me to part it out, PM me.
I also have some other parts that I will post in the thread.
-
interested in all but the manifold sent u a pm thanx ralph
-
How Much For The Intake..
-
I have a rusty timing cover that block off plate can mate to. :)
-
Is anyone interested in this stuff before I list on Ebay?
-
Ah. My old big block Ford parts. Mike what did you end up doing with that motor?
Hot Rod Hallett
-
-
-
Do You Use A Box For The Mallory??or Stock Set Up Or Just A Coil??i Am Intrested If My Truck..later In The Week If You Still Have It Mayb I Can Swing By And Meet You Some Place..i Drive All Over For Work..so We Can Prob Work Something Out..
-
Russo:
Just a coil, I think.... with that Mallory.
Anyone else interested??? :confused: :confused: :confused:
